Toyota 2016 Tacoma Owner's Manual page 422

422
6-4. Other interior features
■
Programming the HomeLink
1
Press and release the HomeLink
and check that the HomeLink
Perform
ing and programming will not be able to be completed.
2
Point the
transmitter for the device at
the rear view mirror, 1 to 3 in.
(25 to 75 mm) from the
HomeLink
Keep the HomeLink
light in view while programming.
3
Perform one of the 2 steps below, depending on device type
being programmed:
 For U.S.A. owners
Press and hold the handheld
transmitter button until the
HomeLink
changes from slowly flashing
orange to rapidly flashing
green (rolling code) or contin-
uously lit green (fixed code),
then release the button.
 For U.S.A. owned entry gates and devices in the Canadian
market
Press and release the remote control transmitter button at 2 sec-
ond intervals, repeatedly, until the HomeLink
changes from slowly flashing orange to rapidly flashing green
(rolling code) or continuously lit green (fixed code).
4
Test the HomeLink
grammed button and observing the indicator light:
● Device with fixed code: If the indicator light is solid/continuous,
programming has been completed and your garage door or
other device should operate when the HomeLink
pressed and released.
3
within 60 seconds of
remote control
®
buttons.
®
indicator
®
indicator
®
operation by pressing the newly pro-
®
®
button you want to program
®
indicator light flashes orange.
,
1
or the indicator light will stop flash-
light
I n f o r ma t i o n P r o v i d e d b y :
®
indicator light
®
button is