Exit; Notice: Bios Spi Rom - DFI BT551 User Manual

Exit

InsydeH20 Setup Utility
Main Advanced Security Power
Exit Saving Changes
Exit Discarding Changes
Load Optimal Defaults
F1 Help ↑↓ Select Item F5/F6
Esc Exit ←→  Select Menu Enter
Exit Saving Changes
Select this field and then press <Enter> to exit the system setup and save your
changes.
Exit Discarding Changes
Select this field and then press <Enter>to exit the system setup without saving your
changes.
Load Optimal Defaults
Select this field and then press <Enter> to load optimal defaults.
Chapter 3 BIOS Setup
Rev. 5.0
Boot Exit
Exit system srtup and save
your changes.
Change Values F9 Setup Defaults
Select SubMenu F10 Save and Exit

Chapter 3

Notice: BIOS SPI ROM

1. The Intel Management Engine has already been integrated into this system board. Due to
®
the safety concerns, the BIOS (SPI ROM) chip cannot be removed from this system board
and used on another system board of the same model.
2. The BIOS (SPI ROM) on this system board must be the original equipment from the factory
and cannot be used to replace one which has been utilized on other system boards.
3. If you do not follow the methods above, the Intel
and will cease to be effective.
Note:
a. You can take advantage of flash tools to update the default configuration of the
BIOS (SPI ROM) to the latest version anytime.
b. When the BIOS IC needs to be replaced, you have to populate it properly onto the
system board after the EEPROM programmer has been burned and follow the
technical person's instructions to confirm that the MAC address should be burned
or not.
37
Management Engine will not be updated
®
www.dfi .com