DFI BT551 User Manual page 32

Primary IGFX Boot Display
Select the Video Device which will be activated during POST. This has no effect if the
external graphics presents. The selection of secondary boot display will appear based
on your selection. VGA modes will be supported only on primary display.
Secondary IGFX Boot Display
Select the secondary display device: CRT, DDI-0 or DDI-1. DDI-0 is the default setting.
Chapter 3 BIOS Setup
Chapter 3
SATA Configuration
This section is designed to select the SATA controller and the type of hard disk drive which are
insalled in your system unit.
Advanced
SATA Controller
F1 Help ↑↓ Select Item
Esc Exit ←→  Select Menu
SATA Controller
Enable or disable the Serial ATA Port.
32
InsydeH20 Setup Utility Rev. 5.0
DISABLED: Disables
<Enabled>
SATA controller.
ENABLED: Enables SATA
conroller.
F5/F6 Change Values F9 Setup Defaults
Enter Select SubMenu F10 Save and Exit

www.dfi .com