Setting & Data View - GRAUPNER mx-16 HOTT Programming Manual

Telemetry
The menus grouped together under the overall heading
"Telemetry" are called up from the basic display of the
mx-16 HoTT transmitter by holding the central
button of the left-hand touch-key pressed in for about
three seconds. An alternative method of calling up this
menu, which also applies to the transmitter's other
menus, is to briefl y press the central SET
right-hand touch-key in the multi-function list:
mod. mem. base sett.
ser vo set. contr set.
D/R expo phase trim
wing mixer free mixer
ser vo disp basic sett
fail-safe telemetr y
Basic menu operation
In general terms the "Telemetry" menu is operated just
like the other menus of the mx-16 HoTT transmitter.
The few differences are described below:
You can switch between the individual pages of the
Telemetry menu using the arrow buttons
left or right-hand touch-key: you will fi nd corresponding
direction indicators at top right of every screen page in
the form of angle brackets (< >); see illustrations. If only
one angle bracket is visible, then you are currently at the
fi rst or last page. In this case it is only possible to switch
pages in the direction indicated by the angle bracket.
Menu lines in which parameters can be altered are
marked with an angle bracket prefi x (>). Pressing the
arrow buttons of the left or right-hand touch-key
causes the ">" pointer to jump forward or back by one
line. Lines to which you cannot jump contain no user-
variable values.
118 Program description: Telemetry menu
If you wish to change a parameter, touch the central
SET button of the right-hand touch-key to highlight the
parameter (black background)). Change the value within
the possible range using the arrow buttons of the right-
ESC
hand touch-key, and then press the
briefl y to accept the value.
The method of returning to the basic display varies
button of the depending on whether you called up the menu from
the multi-function list or from the basic display: you can
return to the basic display either by briefl y pressing the
ESC button again, or by holding
about three seconds.
At this point you can use the arrow buttons
left or right touch-key to select the desired sub-menu.
However, if the message ...
... appears instead of the desired sub-menu when you
touch the central SET
of the then the transmitter has no connection to a receiver. In
this case, switch your receiving system on, or re-bind
the receiver you wish to address, if this should not be
the last bound one; see "Important information" on the
previous page.
SET button again
ESC pressed in for
of the
CAN'T
RECEIVE
DATA
OK
button of the right-hand touch-key,
SETTING & DATA VIEW
SETTING & DATA VIEW
TELEMETRY
SETTING & DATA VIEW
SIMPLE DATA VIEW
RF STATUS VIEW
VOICE TRIGGER
On the fi rst screen page of the sub-menu "Setting &
Data View", headed ...
RX DATAVIEW
... you cannot enter any settings. This page is for infor-
mation purposes only:
RX DATAVIEW
S–QUA100%S–dBM–030dBM
S–STR100% R–TEM.+28°C
L PACK TIME 00010msec
R-VOLT :05.0V
L.R-VOLT:04.5V
SENSOR1 :00.0V
SENSOR2 :00.0V
Value Explanation
S-QUA Signal quality in %
S-dBm Receive performance in dBm
S-STR Signal strength in %
R-TEM. Receiver temperature in °C
L PACK TIME Indicates the time in ms for which
the longest data packet was lost in
transmission between transmitter and
receiver
R-VOLT Current receiver operating voltage, in
Volt
00°C
00°C