User Program Edit Mode - Landice CARDIO Owner's Manual

The Cardio Treadmill can store up to 5 individual, modifiable User-Defined Program Profiles. These programs will be retained
even if the unit is unplugged.
A User-Defined Program looks and runs exactly like a Built-In Program. The primary difference between Built-In and
User-Defined Programs is customization. Unlike the Built-In Programs, User-Defined Programs allow you to manually edit
individual segments as well as the number of segments.
EXITING EDIT MODE
Once you have completed editing your User-Defined Program, you can begin your program by pressing START. If you
attempt to advance the cursor past the 20th segment, you will be prompted with "PRESS START TO BEGIN OR ENTER TO
EDIT". You can also exit Edit Mode by pressing Manual Mode or Programs at any time.
To create a 2-segment User-Defined Program where you first walk at 2 MPH at 1% incline for 30 seconds and then run at 5.5
MPH at 7% incline for 10 minutes you would:
1. Press the PROGRAMS button.
2. Press RIGHT ARROW key 5 times and then ENTER.
3. Press ENTER to enter EDIT MODE.
4. To edit the 1st segment's time press "3", "0", ENTER.
5. To edit the 1st segment's speed, press "2", "0", ENTER.
6. To edit the 1st segment's incline press "1", ENTER.
7. To move to the 2nd segment press RIGHT ARROW key.

User Program Edit Mode

SELECT A PROGRAM
Press PROGRAMS at any time during a workout to display the Programs
Selection Screen. To scroll through the programs, either continue to press the
Programs button or the center Arrow Keys. To select a program, press ENTER
while program is displayed. (For available programs refer to page 10).
USER PROGRAM PREVIEW
The User Program Preview Screen displays the program overview and the total
program time.
Press ENTER or wait 3 seconds. A prompt will appear to "PRESS START TO
BEGIN OR ENTER TO EDIT". Press ENTER to access "EDIT MODE".
EDIT THE SEGMENTS
The EDIT MODE requires a time for segment 1 (area highlighted in white). Use
the Numeric Keypad to change the value and press ENTER. Pressing ENTER
will toggle between speed, incline and time values for that segment. Continue to
program subsequent segments by using the Arrow Keys to move from segment
to segment.
CREATING A PROGRAM WITH LESS THAN 20 SEGMENTS
If you do not want a program to have the full 20 segments, once you are
satisfied with your last segment, create an additional segment with '0' in the
time field. The time will read END. Your User-Defined Program will end upon
completion of the previous segment.
EXAMPLE
8. To edit 2nd segment's time press "1", "0", "0",
"0",ENTER.
9. To edit the 2nd segment's speed press "5", "5", ENTER.
10. To edit the 2nd segment's incline press "7", ENTER.
11. To move to the 3rd segment press RIGHT ARROW key.
12. To make the 2nd segment your last segment press "0",
ENTER so time value reads END.
13. Press START to begin the program.
12