Table of Contents
Advertisement
Starting The Engine
Before starting, read the Pre‑Starting Check List, Special
Operating Instructions, Engine Break‑in Procedure and Gear
Shifting in the Operation Section and the remote control features
and operation in the Features and Controls Section.
Failure to provide sufficient cooling water will damage the water
pump and cause the engine to overheat. Provide a sufficient
supply of water at the water inlets during operation.
1. Make sure the cooling water intake is submerged.
2. Check the engine oil level.
3. Open fuel tank vent on manual venting type tanks.
NOTE: The engine will not start unless the lanyard is set to the
"RUN" position.
OPERATION
NOTICE
27780
19748
90
14836
Advertisement
Table of Contents
