Mounting; Wall-Mounting; Installation - Siemens 6FL7171-8AD Operating Instructions Manual

s
4.1

Mounting

4.1.1

Wall-mounting

The unit should be installed on as even a surface as possible.
•
Create openings for the lead in the bottom section of the housing and pull the lead
through.
•
Screw the bottom of the housing onto the selected position on the wall.
•
End of lead should be fixed at the bottom section (see figure below).
Figure 2: Back view of the bottom section of the housing with the terminal board slotted in
4.1.2

Installation

•
The electronic board (pcb) with terminal connectors is build into the top section of the
housing.
•
Connect the cable to the terminal strip (pcb) in the top section of the housing.
See chapter „5.1 Connecting the reader"
•
First, insert top section of housing on top part of mounted bottom section of the housing.
•
Then, push both parts of the reader housing together. In doing so, keep attention on the
wires.
•
Screw in the safety screw on the underneath of the bottom section of the housing.
Note
The maximum torque of the safety screw is 1,5 Nm.
Operating instructions card reader AR6331-CP / AR6332-CP
Order no.: A24205-A335-H050
GB
9 36
Page from