Remote Control - Siemens REV17 Series Instructions Manual

Enter holidays or
absences

Remote control

Enter temperature for
active remote control
6 / 13
Siemens
Building Technologies
You can enter the beginning, temperature and end of your holidays. At the beginning of
the holidays, the controller switches to the desired holiday temperature and returns to the
previously set operating mode at the end of the holidays.
In holiday mode, symbol
Proceed as follows to enter your settings:
Set slider to position 15 (start of absence): Press
for your holidays.
Set slider to position 16 (temperature during absence): Press
the desired temperature while on holidays.
Set slider to position 17 (end of absence): Press
for your holidays.
Return the slider to position RUN. Symbol
RUN
symbol.
Press , ,
Use a suitable remote control unit to activate the "Remote control"
setpoint in the controller. Changeover takes place by making a potential-free contact
connected to terminals T1 and T2.
A flashing symbol indicates active remote control mode.
After the contact opens, the previously set operating mode is reactivated.
Operation according to controller setting
T1
T2
, ,
Suitable remote control units are:
Telephone modem, manual switch, window contact, presence detector, central unit, etc.
You can freely select the temperature for active remote control. Activating remote control
immediately enables control to the remote control temperature regardless of the currently
active operating mode. When you deactivate remote control, the controller returns to the
set operating mode.
A flashing symbol indicates active remote control mode.
Proceed as follows to enter your settings:
Set slider to position 18 (temperature for active remote control): Press
to set the desired temperature for active remote control.
RUN Return the slider to position RUN.
Room temperature controller REV17..
is displayed along with the end of holiday mode.
, or move the slider to end holiday mode prematurely.
Temperature setpoint "remote control"
,
, ,
or to set the start date
or
or to set the end date
is displayed to the left of the
temperature
active
T1
T2
CE1N2203en
to set
or
24.04.2008