Siemens REV17 Series Instructions Manual page 5

Operating modes
Operation with
time switch program
Example with
3 heating phases
Continuous operating
modes
Setpoints
Factory setting
Weekday /
Weekend -
Time switch
5 / 13
Siemens
Building Technologies
The controller offers the two time switch programs
Enter a start time and end time for each heating phase. Also comfort temperature
setpoint can be freely entered for each heating phases. Between the heating phases
the controller always switches to the same, freely selectable energy saving
temperature setpoint.
°C
22
21
20
Heatin g
ph ase 1
18
16
06
08
The controller also offers the three 3 continuous modes
energy saving mode and
You can freely adjust the setpoints for the weekly and 24-hour operating modes.
Setting range for all setpoints without setpoint limitation 3...35 °C.
Setting range for all setpoints with setpoint limitation 16...35 °C.
Factory settings: Heating
, , ,
,
,
Factory settings: Switching times
Heating phases P1
1. 07:00
2. 06:00
3. 06:00
Three different switching patterns are available to simplify entry of switching times. These
can be assigned as blocks to the corresponding weekdays 1...5 and weekend days
6...7. As a result, you need to adapt the switching times and room temperatures only
once for each block.
Switching pattern
Room temperature controller REV17..
and
Heating
phase 2
14
12
frost protection mode.
20 °C
16 °C
8 °C
12 °C
P2 P3
23:00 PASS PASS
08:00 17:00 22:00
08:00 11:00 13:00
.
Heating phase 3
18 22
comfort mode,
P4 P5 P6
PASS PASS
PASS PASS
17:00 22:00
Blocks
CE1N2203en
24.04.2008
h