User-Defined Settings; Mounting And Installation - Siemens REV17 Series Instructions Manual

Reset
Engineering
Mounting and
installation
Commissioning
Notes
10 / 13
Siemens
Building Technologies

User-defined settings:

, and simultaneously for 3 seconds:
This resets all temperature and time settings of the program selection slider to default
values (see also "Factory settings" in the operating instructions). The expert settings
remain unchanged.
The clock starts at 12 p.m., the date on 01-01-08 (01 - January - 2008).
During the reset, all display fields are lit and can be checked accordingly.
All user-defined settings plus expert settings:
Press the DIP switch reset button
5 seconds:
After the reset, all factor settings are reloaded. This applies to the program selection
slider as well as to the expert settings.
• Mount the room temperature controller in the main living room.
• Select the mounting place so that the sensor can acquire the air temperature in the
room as accurately as possible and without being influenced by solar radiation or
other heat or refrigeration sources.
• Mounting height is approx. 1.5 m above the floor.
• You can mount the unit on most commercially available recessed conduit boxes or
directly on the wall.
•
Begin installation by first attaching and wiring the base. You can mount the base on
most commercially available recessed conduit boxes or directly on the wall. Then
insert the controller from top to bottom into the base.
For more information, see the installation instructions supplied with the unit.
• Comply with all local regulations on electrical installation.
• Wire separately the remote control contact T1 / T2 using a separate, shielded cable.
• Remove from the batteries the battery transit tab designed to prevent premature
activation of the unit: Select desired language by
• You can change the control characteristics using the DIP switch on the rear of the
unit.
• Set any thermostatic radiator valves to their fully open position, if present in the
reference room.
• Recalibrate the temperature sensor (see "Sensor calibration") if the displayed room
temperature does not match the room temperature measured.
This is a software class A controller designed for use at a normal degree of pollution.
Room temperature controller REV17..
ON
1 2 3 4 5 6 7 8 9
, and simultaneously for
or . Confirm by .
CE1N2203en
24.04.2008