Table of Contents
Advertisement
Installation Guide
LP10RF Installation
DANGER:
F
230 volts do not touch the electrical
components or circuits.
CAUTION:
Isolate the mains electricity supply
before starting any work and observe
!
all relevant safety precautions.
Observe electro-static discharge
precautions: do not touch the pcb
circuit.
Cover panel
Cover panel
Screw
Screw
Tab
Tab
Blanking
Blanking
plate
plate
Programmer
Programmer
Ribbon cable
Ribbon cable
Connector plug
Cover panel
Cover panel
Screw
Screw
4
Tab
Tab
Clips
Clips
Recess
Recess
Connector plug
Clips
Clips
LP10RF Programmer & Receiver
NOTE:
This accessory must be fitted by a competent person.
Failure to comply could lead to prosecution.
Cover panel
Screw
1
Remove the boiler outer casing and control panel
fascia to gain access to the boiler control panel.
2
Release the securing screws.
3
Pull the cover panel up to remove.
Tab
4
Grip the tab and pull upwards to disengage clips,
pull forward to remove blanking plate or existing
programmer.
Blanking
5
Align the connector plug pins into socket on the
plate
PCB and push fully home.
6
Feed the ribbon cable into the recess.
7
Align the programmer and locate the clips, push
Programmer
into the slots then down to secure.
8
Locate the cover panel in place and secure with
the screw.
9
Replace fascia cover and outer casing before
switching on the electrical supply and boiler.
Switch boiler on when completed.
J
Ribbon cable
Connector plug
Cover panel
Screw
Tab
Programmer
Clips
Recess
Clips
Installation & User Guide
Hide quick links:
Advertisement
Table of Contents
