Drayton LP10RF Installation & User Manual page 8

Installation Guide
Positioning the Digistat +2RF room thermostat
The Digistat is a radio frequency device which is very
flexible for positioning as there is no need for hard wiring
to the appliance. The device should be mounted in an
open area, no closer than 30cm from metal objects,
including wall boxes.
Mount the Digistat+2RF on a wall which is not subject
to direct sunlight or draughts, preferably on an inside
wall, 1.5 metres above the floor. The Digistat+2RF must
also not be directly influenced by radiators or other
appliances giving off heat.
Mounting the Digistat +RF room thermostat
1 Remove the front cover using a flat screwdriver and
separate from back plate.
2 Fix the back plate directly onto the wall using the
allocated fixing points and suitable wall plugs and
screws.
3 Replace the front cover by locating in position and
pushing fully onto the back cover.
6
LP10RF & DIGISTAT+2RF
4 Remove the battery cover using a coin
5 Install the 2 AA batteries provided
6 Replace battery cover
To cancel signal strength mode:
1 Remove the batteries from the Digistat+2RF
transmitter to cancel the constant transmission.
2 After a few seconds the receiver display will show
'---' .
3 Press 'OK' on the LP10RF receiver and the display
will return to the time with the 'CH and Antenna'
flashing.
4 Re-insert the batteries into the transmitter and the
RF link will be re-established.
Installation & User Guide