The Standard Program - Drayton LP10RF Installation & User Manual

User Guide

The Standard Program

NOTE:

The ON/OFF periods pre-programmed for Hot
Water pre-heat are shown in the table opposite. The
factory installed settings can be used without any
further programming of the receiver. The date and
time are pre-programmed and should not require
adjustment.
If you need to restore the factory pre-set program
times then:
Press the + and - buttons together, for three seconds or
longer, to restore the default program times to those
shown in the table opposite.
Switching
1st ON - start of first timed period
1st OFF - end of first timed period
2nd ON - start of second timed period
2nd OFF - end of second timed period
3rd ON - start of third timed period
3rd OFF - final swith-off of the day
LP10RF & DIGISTAT+2RF
Client
Artworker
Creative Director
Modification Date
NOTE:

Two ON/OFF periods can be used instead of three,
by setting the second ON/OFF periods to 12:00 as
shown in the default program table.
One ON/OFF period can be achieved by setting the
second and third ON/OFF periods to the same time.
See Changing the Program on the next page, if changes
are required to the clock time or pre-programmed
settings.
Weekdays
Drayton File Name 7542 Drayton LP10RF & DIGISTAT+2RF 06515086001 ISSC
-
PRINT
Mike Lane
Proof Stage
21/08/15 2:56PM
LP10RF Programmer & Receiver
LP10RF
Weekends
HW
6.30am
8.30am
12.00pm
12.00pm
4.30pm
10.30pm
Finished Size A5 148x210mm
Artwork % 100%
Bleed 3mm
HW
7.00am
9.00am
12.00pm
12.00pm
4.00pm
11.00pm
21