Lp10Rf Programmer & Receiver - Drayton LP10RF Installation & User Manual

User Guide
LP10RF Programmer & Receiver
If the engineer has set your program and timings – you do
not need to do anything else. Just keep this guide in a safe
place for future reference.
Introduction
The programmer will automatically switch your hot
water on and off at times that suit you.
Modes:
off = continuously off.
timed = on for up to 3
periods a day as
program
once = on for 1 period a
day, from the start of
1st ON to the end of
3rd OFF as program.
on = continuously ON
Hot water
pre-heat
ON LED
Hot water pre-heat
select button, moves
the mode indicator up
and down to select
and accept changes
Press to select each setting:
date, time, program and
holiday function
Normal Operation
During normal operation the receiver will flash the red
LED, approximately every five minutes. This indicates that a
radio signal is being received from the Digistat transmitter.
Radio Signal Loss
If the red LED does not flash approximately every five
minutes then the receiver will show a flashing green
LED together with the flashing antenna symbol and the
Central Heating indicator arrow will point to OFF. This
situation indicates that the radio signal link from the
20
Time and day
Mode indicator indication
+ and - changes ON/OFF
programmed times
LP10RF Programmer & Receiver
The green light on the front of the programmer shows
when it is on. LP10RF has a 7-day program allowing for
different timings on each day of the week, for up to 3
heating periods each day.
If the engineer hasn't set your timings for you, your
programmer will work with a standard program that has
been set at the factory. If this doesn't suit you, it's very
easy to change it.
RF link
Pre-heat advance button:
turns ON until next OFF time OR
turns OFF until next ON time
Press OK to adjust each
program setting
Digistat transmitter has been lost. This may be remedied
by fitting new batteries in the Digistat transmitter. If
fitting new batteries does not restore the link, then
temporarily move the Digistat transmitter close to the
appliance, if this does not restore the link, then technical
help must be sought to remedy the failed radio signal link.
Temporary Override
While the RF link is lost, the Central Heating can be
switched ON by pressing the OK button once and
switched OFF by pressing the OK button again. In this
mode the room temperature will not be controlled.
NOTE:

LP10RF
Advance
has no
effect with
constantly
on or off is
selected on
the receiver
or when
there is no
demand
from the
transmitter.
Installation & User Guide