Table of Contents
Advertisement
User Guide
Setting holidays:
1
Press the set? button until SET and HDAY? are
displayed.
HDAY?
HDAY?
2
Press OK and the display shows 00.
00
00
HDAY?
00
03
3
Press + or - to set the number of days you require
03
the system to be off.
HDAY?
03
00
HDAY
4
Press set? then HDAY is shown in the display and
no demand for heating will be made from the
HDAY
03
programmer. The program will return to normal
after the set number of days. To cancel the holiday
HDAY
setting and return to normal operation, press any
button.
HDAY
NOTE:
The programmer counts each pass through midnight
as a day. e.g. if you do not want heating from Saturday
morning until Tuesday morning, set for three days.
24
Setting the clock and time
1
Press the set? button until SET and CLOCK? are
shown in the display.
2
Press OK to display 24hr and ON.
6:30
3
Press + to switch between 24hr and 12hr display.
6:30
4
Decide between 24 hour or 12 hour display and
press set? to select, now the hours will flash.
6:30
5
Press + or - to set the correct hour.
6:30
NOTE:
Speed up the display by holding down the + or -
buttons.
6
When the correct hour has been selected, press
set? to select, now the minutes will flash.
7
Press + or - to set the correct minutes.
8
When the correct minutes have been set, press set?
to select that setting.
■ ■
■ ■
■ ■
LP10RF Programmer & Receiver
CLOCK?
CLOCK?
CLOCK?
CLOCK?
CLOCK?
36
36
36
36
Now SET and DATE will be displayed.
DATE?
36
If the day and date needs resetting, refer to
the next page for SETTING THE DATE.
DATE?
DATE?
If the day and date are correct, press set? to
return to the normal display.
DATE?
DATE?
Installation & User Guide
6:30
6:30
6:30
6:30
6:30
Hide quick links:
Advertisement
Table of Contents
