Wireless Commissioning & Signal Strength - Drayton LP10RF Installation & User Manual

Installation Guide
Wireless Commissioning
& Signal Strength
Before fixing the DIGISTAT+2RF to the wall it is
recommended to first check the signal strength from that
location.
To do this, after initial start up, the colon, CH and antenna
symbols should be flashing on the LP10RF display.
CLOCK?
1 Press the set? button 4 times.
2 Press the OK button once.
OFF
3 Press the set? button 4 times; Lrn and OFF should
CLOCK?
be displayed.
OFF
CLOCK?
4 Press the + button so the display shows ON and a
CLOCK? OFF
flashing antenna symbol. The learn mode is now
ready to receive a signal from the transmitter
during the next two minutes.
OFF
5 Take the Digistat+2RF unit and stand near the
boiler.
6 Remove the battery cover and fit the batteries.
7 The symbols on the receiver will stop flashing and
the display will show 'SSI, Antenna and ON'.
Press 'SET' on the receiver and the display will
8
show 'SSI and Antenna'.
LP10RF & DIGISTAT+2RF
Client
Artworker
Creative Director
Modification Date
9
J
K
10:30

10:30
If there is no LED and the display shows '- - -', there
is no signal being received at all from the transmitter.
Transmission will resume once the transmitter is re-
positioned in a part of the house where an amber or
10:30
green LED and 3 or 4 chevrons are achieved.
6:30
L
10:30
6:30
6:30
6:30
LED indicator shows different colour depending
on signal strength (see table below)
LED Indication
Green
Amber
Red
None
Drayton File Name
-
Mike Lane
Proof Stage
21/08/15 2:56PM
LP10RF & DIGISTAT+2RF
After a few seconds the display will show '- - -'.
Remove the batteries from the Digistat+2RF,
press and hold the '+' button whilst refitting the
batteries, keep the '+' button held and after a few
seconds the display will show 'rF' which indicates
that the DIGISTAT+2RF is continuously sending a
signal to the LP10RF (receiver).
The receiver display will now show the 'learnt'
transmitter code and the antenna' as well as the
signal strength as indicated by the chevrons on the
right hand side of the display.
P lace the transmitter in the desired final position
and return to the boiler to check the receiver
display. The ideal transmitter position will result
in the receiver display showing 4 chevrons and the
LED will be green.
I f the LED is red or no LED is showing and the
display indicates 1 or 2 chevrons, the transmitter
will need to be re-positioned until the LED
changes to amber or green and 3 or 4 chevrons are
indicated on the display.
NOTE:
O nce you are happy that, when in the desired
location, the transmitter is sending a good signal
to the receiver i.e. amber or green and 3 or 4
chevrons, the transmitter can be fixed to the wall.
Chevrons
4
3
2
1
7542 Drayton LP10RF & DIGISTAT+2RF 06515086001 ISSC
Finished Size
PRINT
Artwork %
Bleed
Signal strength
indicators
Transmitter code
(may be different)
RF Strength
Very strong
Strong
Weak
Very weak
5
A5 148x210mm
100%
3mm