Signal Strength - Drayton LP10RF Installation & User Manual

Installation Guide

Signal Strength

Signal Strength
To check signal strength on previously
installed and paired units:
1 Press the 'set' button 4 times on the LP10RF.
2 Press 'OK' once.
3 Press the 'set' button 5 times. The display will show
'SSI and OFF'.
OFF
OFF
4 Press the '+' button so that the display shows 'SSI,
Antenna and ON'.
OFF
OFF
5 Press the 'set' button so the display shows 'SSI and
Antenna'.
6 After a few seconds the display will show '---'.
7 Remove the batteries from the Digistat+2RF
transmitter and wait until the display has faded
away.
8 Press and hold the '+' button on the transmitter
while re-inserting the batteries and keep the button
depressed until the display shows 'rF' .
LP10RF & DIGISTAT+2RF
Client
Artworker
Creative Director
Modification Date
LED indicator shows different colour depending
Transmitter code
on signal strength (see table below)
(may be different)
LED Indication
Green
Amber
Red
None
To cancel signal strength mode:
LED indicator shows different colour depending
on signal strength (see table below)
1
2
3
6:30
6:30
6:30
6:30
4
Drayton File Name 7542 Drayton LP10RF & DIGISTAT+2RF 06515086001 ISSC
-
PRINT
Mike Lane
Proof Stage
21/08/15 2:56PM
LP10RF & DIGISTAT+2RF
Signal strength indicators
Chevrons
4
3
2
1
Remove the batteries from the transmitter to
cancel the constant transmission.
After a few seconds the receiver display will show
'---' .
Press 'OK' on the receiver display and the display
will return to the time with the 'CH and Antenna'
flashing.
Re-insert the batteries into the transmitter and the
RF link will be re-established.
Finished Size A5 148x210mm
Artwork % 100%
Bleed 3mm
Signal strength
indicators
Transmitter code
(may be different)
RF Strength
Very strong
Strong
Weak
Very weak
7