Adding And Checking The Oil - ALDI 52371 User Manual

140cc 4 Stroke Petrol Lawn Mower

Adding and Checking the oil

IMPORTANT: This lawn mower is packed with NO OIL in the motor. Prior to
starting the motor, Oil MUST be added to the sump of the motor.
Failure to add sufficient oil will result in damage to the motor which is
NOT covered under the warranty of the lawn mower.
On a new lawn mower, the motor needs to be filled with 470ml of SAE 10W-30
engine oil.
Each time the lawn mower is used, the oil level should be checked and if low,
add sufficient oil to ensure the oil level is to the full mark on the dipstick.
1. Position the lawn mower on a flat and level surface. Clean the area
directly around the oil filler cap (19).
2. Remove the oil filler cap / dipstick (19) by
turning approximately half a turn in an anti
clockwise direction and lift the cap outwards.
Clean the oil dipstick (19) with a clean cloth,
cleaning away any visual oil (Fig K).
3. FOR A NEW LAWN MOWER, add 470ml of SAE
10W-30 engine oil.
4. Insert the oil dipstick back and secure the oil
filler cap (19) by turning approximately half a
turn in a clockwise direction.
5. Again remove the oil dipstick (19) and check
the oil level. It should be at the top of the full
indicator on the dipstick (Fig L).
6. If low, add oil slowly into the engine oil fill.
Do not overfill. After adding oil, wait one
minute and then recheck the oil level.
7. Replace and tighten the oil filler cap / dipstick
(19). Always ensure the oil filler cap is firmly
locked in place before the motor is started.
NOTE: Do not over fill with oil above the full
indicator mark.
AFTER SALES SUPPORT
1800 909 909
(toll free)
K.
L.
e-mail: help@powertoolsupport.com
MODEL: №. 52371 • 03/2016 • 52371
17