Operation; Setting The Cutting Height; Starting The Engine - ALDI FERREX XSZ46I User Manual

GB IE

Operation

smoke or allow flames or sparks in the area where the engine is
refueled or where petrol is stored. Avoid repeated or prolonged
contact with your skin or inhalation of vapour. Clean the area
around the petrol filler cap before removing the cap. Remove the
warning tag, check the fuel level.
Refill the tank if the fuel level is low (fuel tank capacity is 0.8 L).
Refuel carefully to avoid overfilling or spilling fuel. There should
be no fuel in the filler neck.
Clean up any overflow or splashes of petrol before starting the
engine.
Tighten the filler cap after filling, finger tight only.
NOTE!
Do not use wasted or regenerated oil that can cause damage to
the engine.
Operation
1. Setting the Cutting Height (Fig 9)
NOTE!
The blade can cause serious injury. Before adjusting the mower
height, stop the engine and wait for the mower blade to stop
completely.
Pull the lever towards the wheel, then move it forwards or
46CM Petrol Lawnmower
19
46CM Petrol Lawnmower
backwards to adjust the cutting height. Move it to any one of
the 7 positions (25~75mm) for the desired cutting height; Ensure
the lever clicks into place.

2. Starting the Engine

Starting procedure quick guide (Fig 10)
NOTE!
Do not operate the machine in enclosed or poorly ventilated
areas as the exhaust contains toxic substances. Keep hands,
feet, hair and clothing away from all the moving parts of the
machine. The exhaust and other parts of the machine will
become hot during use. The user shall start the engine behind
the lever.
NOTE!
To start the engine, make sure that the spark plug cap is located
on the plug and the machine is filled with sufficient oil and
petrol.
NOTE!
Press down the primer for 3 times before pulling the engine
cord handle.
20
GB IE
Operation