Electrical Connection; Connection; Power Cable; Position Of The Fuses In Control Unit - Bosch Therm 6000 S Installation And Operating Instructions Manual

24 | Electrical connection

7 Electrical connection
DANGER: Risk of electric shock!
Always disconnect the power supply to
the appliance at the mains before
carrying out any work on the electrical
systems and components.
All regulation, veri cation and
rigorously tested in the factory and are ready for use.
CAUTION: Fuse protection!
The appliance should have an
independent connection to the electricity
mains, protected by a di erential 30 mA
switch and be earthed. In areas subject to
frequent storms, a storm protector
should be installed.

7.1 Connection

The electrical connection should be
according to current regulations regarding
domestic electrical installations.
An earth connection is absolutely
essential.
Connect the feed cable to an earthed power point.

7.2 Power cable

The appliance is provided with a labelled power cord and
earthed mains plug.
If the power cable gets damaged it must be
replaced by a genuine spare part.
6 720 800 095 (2014/05)
safety mechanisms have been
Fig. 38 Power cable connections

7.3 Position of the fuses in control unit

To check fuses, proceed as follows;
Remove the front cover, see Fig. 23.
Remove the three screws from the control unit (Fig. 39 and
Fig. 40, [1]).
Fig. 39
Remove the six screws from th e back cover of the control
unit, see Fig. 40, [2].
6720608913-09.1AL
6720608920-38.1Av
Therm 6000S