Bosch Therm 6000 S Installation And Operating Instructions Manual page 33

Intake
1 Straight section length
2 90° elbows (qty)
3 45° elbows (qty)
4 30° elbows (qty)
5 S b u t - t o : l a
6 Total equivalent vent length=
Table 19
Note: Do not count terminals and rst elbow used on intake and
exhaust.
Total maximum length for separate tubes
(exhaust/admission) must not exceed 16
meters.
8.6.2 Adjusting fan speed
After obtaining the total sum of the conducts, proceed as
follow:
Press ON/OFF button into OFF.
Press and hold "Program" button and press ON/OFF button
to turn appliance ON (see Fig. 47 ).
Fig. 47
As soon as '188' is displa y ed, release "Program" button
, and the display should read P2.
Press one time to access the program P2. In the LCD
display is visible the attributed value (factory value: GN: 8,
LPG:7).
Press or to choose the fan speed suitable with
your installation, see tab.20 for separate tubes admission/
exhaust Ø 80/80 mm.
Press and hold ( 5 sec.) "Program" button
display ashes.
Selected valu e is memorized.
Therm 6000S
_4_ x 1= 4
_1_ x 1 = 1
_0_ x 0.5 = 0
_0_ x 0.4 = 0
5
12
until the
Fan speed for separate tubes Ø80/80 mm
Mode Conduct length
P2 From 1 m until 6 m
from 6.1 m until 14 m
from 14.1m until 16 m
Table 20
1) Total conducts lengths of Table 17. Do not count with the
rst elbow and the accessory of wind/rain protection.
Do not set P2 to greater then 10.
Installation instructions | 33
1)
Fan speed
GN LPG
8 7
9 8
10 9
6 720 800 095 (2014/05)