Table of Contents
Advertisement
14 | Installation instructions
4.11 Reset button
This appliance has a e rror codes system. The
visualization of these codes is made through
the LCD display. (Fig. 4, [4]).
If the LCD shows the error symb
or unplug the heater. Follow instructions below to reset error
rst.
Record the error code on LC D and consult chapter 10 to
identify the error.
Fig. 18 Error code
After following instructions in
section,
press reset button rmly in orde
operation.
Fig. 19 Reset button
If the problem persists, contact your installer.
6 720 800 095 (2014/05)
ol
do not shut o power
dicated in "Troubleshooting"
r to return heater to normal
4.12 Locked condition
This condition is only valid fo
remote controls installed.
Fig. 20 Locked condition
Whenever LCD shows
be adjusted because the appliance is in use by a user which
already selected a di erent temperature. Appliance will be
automatically unlock 5 minutes after closing hot water tap.
5
Installation instructions
DANGER: Explosion!
Always close the gas valve before doing
any work in gas components.
The installation, the electric connection, the
gas installation, the installation of the
exhaustion / admission conducts, as well as
the start up must be carried out by a quali ed
technician.
The appliance can only be used in the
countries mentioned in the type plate.
CAUTION:
Do not install the appliance where the
inlet water temperature is superior to
60 °C. In such cases we recommended
the installation of a mixer's valve in the
entrance of the appliance as prevention
measure.
r appliances with one or more
6720608920-33.1AL
the temperature setting cannot
Therm 6000S
Hide quick links:
Advertisement
Table of Contents
