Program Values - Bosch Therm 6000 S Installation And Operating Instructions Manual

30 | Installation instructions

8.4 Program values

This section describes details on programming the appliance.
For most applications the fact
robust and stable operation.
Program Description
P1 Maximum Power N. Gas: 40
P2 Minimum Power N. Gas: 8
P3 Remote
Controls installed
P4 Access to
Diagnostic Mode
P5 Cascade Mode
P6 Temperature Unit °C
P7 Appliance Type nO
P8 Back light
P9 Fan Purge
PH Cascading type IC
PC Master/Slave
mode
Table 12
6 720 800 095 (2014/05)
ory default values will provide
Factory default Min
21
LPG: 37
N. Gas: 8
LPG: 7 LPG: 7
_0 _0
E 0d
nO nO
°F
Cd
(condensing)
dE dE
IC
CS CS
CAUTION: Misadjusted program values
can lead to appliance malfunction, errors,
and service calls.
Max Comment
N. Gas: 40 See chapter 8.2.
LPG: 37 Note: reducing P1 values below maximum
will reduce maximum power of the
appliance.
20 See chapter 8.2.
6 See chapter 4.6.
10f See chapter 8.5.
CC To activate the cascade mode it's necessary
to install the "kit cascade" (cod. 7 736 500
272)
°C See chapter 8.5.
nO Condensing / Non-condensing
note: incorrect setting will cause errors.
On dE: turns back light o after 60 seconds
from last button pushed.
ON: turns backlight on permanently.
Runs secondary fan and primary fan when
P9 is selected by depressing the "P" - button
SC
This menu is only available when cascade
mode is selected CC.
Cn
Therm 6000S