Sanyo VCC-9300 Instruction Manual page 28

CAMERA SETTINGS
White balance additional settings 2
ATW setting
Automatic white balance settings are completed when ATW is
selected. However, white balance will not be suitably adjusted if a
bright light source or an excessively dark area from the
environment is in the image. In this case, the bright light source or
dark area should be masked so that it will not be detected.
1
Use the joystick lever (j or l) to move the cursor to
ATW for WHITE BALANCE and press the ENTER button.
The ATW SETTING screen will appear.
ENTER
2
Use the joystick lever (j or l) to select ON for
MASKING, then press the ENTER button.
The ATW MASKING screen will appear with the mask pattern
blinking in the upper left corner of the screen.
ENTER
3
Use the joystick lever (j l d c) to move the mask
pattern over the bright light source, then press the ENTER
button.
Use the same steps to place addition masks as needed.
ENTER
Note: Initial settings place no masks on the screen. To cancel the
placement of masks, press the ENTER button again.
English
VIEW SETTING 1
IRIS AUTO ‚
WHITE BALANCE ATW ‚
SHUTTER OFF
MOTION OFF
APERTURE ON ‚
ATW SETTING
MASKING ON ‚
SMART ATW OFF
ATW MASKING
CONTINUE (ñ)
ATW MASKING
CONTINUE (ñ)
– 27 –
4
Use the joystick lever (j or l) to move a mask pattern to
the bottom area of the screen and continue holding the
joystick lever straight down for 3 seconds.
The PRESET and MENU items will appear on the screen. Use
the joystick lever (j or l) to select BACK, then press the
ENTER button. The ATW SETTING screen will reappear.
ENTER
SMART ATW setting
If saturation is high or a scene is bright, the most suitable colors
may not be obtained. In this case, set the SMART ATW to ON.
5
Use the joystick lever (j or l) to move the cursor to
SMART ATW, then use the joystick lever (d or c) to set
ON.
6
Canceling a settings screen
•
Use the joystick lever (l) to select BACK for MENU, then
press the ENTER button. The VIEW SETTING screen will
reappear.
•
To return to the normal screen, use the joystick lever (l
c) to select END for MENU, then press the ENTER button.
ATW SETTING
MASKING ON ‚
SMART ATW OFF
PRESET OFF
MENU BACK
ATW SETTING
MASKING ON ‚
SMART ATW ON
PRESET OFF
MENU BACK