Table of Contents
Advertisement
You can control excessive event logging and remote notification of motions detected after the motion dwell time by
adjusting the motion ignoring dwell intervals. Highlight the box beside Motion Ignoring Interval and press the
button. A list of intervals ranging from 1 to 5 seconds or Never appears. The DVR will not log and notify motion
events occurred during the preset interval range.
NOTE: The record action for motion events will not be affected by the Motion Ignoring function.
Highlighting the box beside Daytime Setup and pressing the
Highlight the Actions tab, and the Motion Detection Actions setup screen
Figure 43 ─ Motion Detection Actions setup screen
NOTE: For the Record action, the camera you select should be set to the Event or Time & Event recording mode
in the Record Schedule setup screen.
Highlight the box under the Alarm-Out heading and press the
internal buzzer) that you would like to activate and to sound whenever the DVR detects motion on the selected camera's
input.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to the Event mode in the
Alarm-Out setup screen (Schedule tab).
Highlight the box under the Notify heading and press the
Notification and pressing the
button. Highlight OK and press the
pressing the
NOTE: For the Notify action, the notify item you select should be enabled in the Notification setup screen and
the DVR should be registered in the RAS (Remote Administration System).
Highlight the desired box under the PTZ heading, and press the
preset position for each PTZ camera, where you want PTZ cameras to move to whenever the DVR detects motion on
the selected camera's input.
Highlight the box beside Daytime and press the
buttons to set the Daytime range. The DVR will consider the remaining time range as
the Nighttime.
button. You can toggle the individual items On and Off by highlighting that item and
button allow you to set up the Daytime range.
appears.
The DVR can be set to react to motion detection differently
for each camera. Each camera can be associated with another
camera, trigger an Alarm-Out connector, sound the DVR's
internal buzzer, notify a number of different devices, and/or
move PTZ cameras to preset positions.
NOTE: You can associate multiple cameras with a camera
that detects motion.
Highlight the box under the Record heading and press the
button. A list of cameras appears. You can associate as many
cameras with that camera as you wish. If the DVR detects
motion on the selected camera, it starts recording video from
all the associated cameras.
button. Select between Alarm Output and Beep (DVR's
button. You can toggle the entire list On and Off by highlighting
button to accept your changes.
button. A list of PTZ presets appear. Select the
4-Channel Digital Video Recorder
button. Use the Up and Down arrow
31
Advertisement
Table of Contents
