Eneo DLR1.2/04&250DV Operating Instructions Manual page 53

Export
Selecting (Export) in the Search menu displays the following Export menu. See the following Clip Copy section
for details.
A–B Clip-Copy: Selecting A–B Clip-Copy will set the starting point of the video to be clip copied,
and the
will set the ending point of the video to be clip copied and displays the Clip-Copy screen.
Clip-Copy: Select Clip-Copy, and the Clip-Copy screen appears to allow clip copy setup.
Camera Menu
Selecting (Camera Menu) in the Search menu displays the following Camera Menu.
NOTE: The video signal has a time difference of 1/60 second (1/50 second for PAL) between odd and even fields
because it is composed of 60 interlaced fields per second (50 fields for PAL). When recording video with Very
High (D1) resolution, video is made up of frame units combining two fields – one odd field and one even field.
This can cause horizontal scan lines or flashes in areas with motion because of the time difference between the
two fields. Turning on the de-interlace filter provides clearer video by eliminating these horizontal scan lines
and flashes.
NOTE: The Camera Menu also can be displayed by clicking the right mouse button on the screen while in the
search mode.
Alarm Reset
Selecting (Alarm Reset) in the Search menu resets the DVR's outputs including the internal buzzer during an alarm.
It is the same as pressing any button on the front panel when the alarm is activated.
Panic
Selecting (Panic) in the Search menu starts panic recording of all cameras, and selecting
It is the same as pressing the Panic button on the front panel.
Data Source
(Data Source) in the Search menu allows you to select the data source to be searched. Selecting Record
Selecting
searches recorded data on primary storage installed in the DVR, and selecting Other searches recorded data on storage
used for another DVR then installed in this DVR.
Exit
Selecting (Exit) in the Search menu exits the search mode and enters the live monitoring mode.
icon displays at the bottom-left corner of the screen. Selecting A–B Clip-Copy again
Zoom: Selecting Zoom and choosing the camera number zooms the current playback image
of the selected camera on the screen. It is the same as pressing the
panel. Selecting Zoom again exits the Zoom mode.
Enable De-Interlace: Selecting Enable De-Interlace turns the de-interlace filters on.
4-Channel Digital Video Recorder
button on the front
Zoom
again stops panic recording.
45