Eneo DLR1.2/04&250DV Operating Instructions Manual page 25

Highlight the Port Number Setup... box and press the
NOTE: You will need to get the appropriate Port Numbers for each RAS and WebGuard related program (Admin,
Callback, Watch and Search) from your network administrator.
NOTE: Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected
with the PC running RAS or WebGuard.
CAUTION: When changing the port settings, you must change the port settings on the PC running
RAS or WebGuard as well. Refer to the RAS manual for details.
button. The Port Number Setup screen appears.
Change the numbers by highlighting them and using the Up and Down arrow buttons
to increase or decrease the number. The factory default Port settings are:
Remote Admin:
Remote Callback:
Remote Watch:
Remote Search:
Selecting DHCP from the Type and highlighting Save
button reads the current IP address of the DVR configured
by DHCP (Dynamic Host Configuration Protocol) network.
Selecting ADSL (with PPPoE) allows you to set up the ADSL
network.
Highlight the box beside ID and press the
keyboard appears allowing you to enter the ID for ADSL
connection.
Highlight the box beside Password and press the
A virtual keyboard appears allowing you to enter the password
for ADSL connection.
NOTE: Entering the ID and Password and highlighting OK
reads the current IP address of the DVR configured by the
ADSL network.
NOTE: If the DVR is configured for DHCP or an ADSL
network, the IP address of the DVR might change whenever
the unit is turned on.
4-Channel Digital Video Recorder
8200
8201
8016
10019
button. A virtual
button.
17