Table of Contents
Advertisement
You can also toggle On and Off self-diagnostic events as part of your search. The choices are:
Panic Record
Check Recording
Check Alarm-In
Disk Almost Full
Disk Bad
Disk Temperature
Disk S.M.A.R.T.
Fan Error
Once you set your desired search conditions, highlight Search and press the
the Event Log Search screen. Selecting Cancel exits the screen without saving the changes.
Record Table Search
< Compact View >
< Standard View >
< Expanded View >
Figure 61 ─ Record Table Search screen.
There are three view modes. Standard view, Expanded view and Compact view. Standard view (default) displays
combined recording information of all camera channels currently displayed on the screen. In the Standard view mode,
selecting the
icon located at the bottom switches to the Expanded view mode. The Expanded view displays the
recording information of each camera channel currently displayed on the screen. Selecting the
view mode switches to the Compact view mode which displays only the toolbar. Selecting the
view mode switches to the Standard view mode, and selecting the
Standard view mode.
Selecting
or
located at the bottom zooms the record table. Selecting
selecting
displays 24 hours (3-minute based) at once. To move to earlier or later times that are not shown in the current
record table screen, select the arrows located at the end of the times by using the arrow buttons on the front panel.
NOTE: If the DVR has images recorded in more than one recording mode in the same time range, the recording
status bar displays recording information in the following priority order: Panic
The color of the bar indicates different recording modes: Red for Panic, Yellow for Pre-Event, Purple for Event,
and Blue for Time.
Selecting
located at the bottom displays the Calendar Search screen. See the following Calendar Search section for
details.
button to display the search results in
Recording information about video images currently displayed
on the screen displays on the recording status bar. A grey
vertical line indicates the current search position. To search
specific video, move the vertical line by using the Left or
Right arrow buttons on the front panel or by clicking the mouse
on the desired segment.
If the DVR's time and date have been reset to a time that is
earlier than some recorded video, it is possible for the DVR
to have more than one video stream in the same time range.
In this case, the overlapping time range in the record table will
be separated by a yellow vertical line.
NOTE: The recorded data in the time range located after
the yellow vertical line is the latest.
icon in the Expanded view mode switches to the
displays eight hours (1-minute based), and
4-Channel Digital Video Recorder
icon in the Standard
icon in the Compact
Pre-Event
Event
Time.
47
Advertisement
Table of Contents
