Removing Memory Modules; Preliminary Steps - Fujitsu PRIMERGY CX2550 M1 Upgrade And Maintenance Manual

Main memory
7.3

Removing memory modules

Upgrade and Repair Unit
(URU)
Tools: tool-less
7.3.1

Preliminary steps

Perform the following procedures:
"Disabling SVOM boot watchdog functionality" on page 54
Ê
Ê Locate the desired server node.
"Shutting down the server node" on page 39
Ê
Ê If applicable, remove all external cables from the server node.
"Removing the server node from the server enclosure" on page 40
Ê
Ê Disconnect the SATA cable(s) from the connectors on the system board
described in section
the chassis.
"Removing the memory slot air ducts" on page 48
Ê
Ê Identify the desired memory slot according to the mounting order described
in section "Memory sequence" on page
V
CAUTION!
Ensure to maintain an operational configuration when removing
memory modules. For additional information, please refer to section
"Operation modes" on page
124
"Cabling for HDD 2.5"" on page 208
120.
Upgrade and Maintenance Manual
Hardware: 5 minutes
and take it out of
118.
CX2550 M1