Mounting A Controller To The Riser Module; Concluding Steps - Fujitsu PRIMERGY CX2550 M1 Upgrade And Maintenance Manual

6.3.1.2

Mounting a controller to the riser module

Figure 29: Mounting a controller to the riser module
Ê Plug the controller on the riser card connector (1).
I
Make sure that the metal pin of the controller bracket hooks into the
recess of the riser bracket (see circle).
6.3.1.3

Concluding steps

Perform the following procedures:
"Installing the riser module" on page 43
Ê
"Installing the server node in the server enclosure" on page 50
Ê
Ê Reconnect all external cables.
"Controls and indicators on the server node" on page 51
Ê
"Updating RAID controller firmware" on page 67
Ê
"After replacing / upgrading LAN controllers" on page 83
Ê
CX2550 M1
Upgrade and Maintenance Manual
Expansion cards
(if applicable)
(if applicable)
109