Assembling Components Not Included In The Basic Set - Nikon ECLIPSE TS100 Instructions Manual

2 Assembling Components Not Included in the Basic Set

■ For TS100LED MV/TS100LED-F MV
(1) Turn off the power of the microscope (press the power switch to the "○" position).
(2) Connect the socket of the specified power cord to the AC inlet on the rear of the
microscope and connect the plug to an AC electrical outlet.
Make sure that the power cord is securely connected.
This ends the assembly of the basic set.
Assembling Components Not Included
2
in the Basic Set
1
Components for phase contrast
microscopy
An ELWD condenser, objective for phase contrast
microscopy, phase slider (either centerable or
non-centerable), annular diaphragm Ph2 (when Ph2
objectives are used), GIF filter and centering
telescope (only when a centerable phase slider is
used) are required in order to perform phase
contrast microscopy.
Attach the condenser and objectives in the same
manner as described for the basic set. For details
on the centering telescope, please see the
description given in Chapter 3, "Microscopy".
Insert the annular diaphragm Ph2 to the slider if
you are planning to use an objective having a Ph2
indication.
Insert the slider with annular diaphragm attached
into the condenser slider attachment hole.
2
Components for NAMC microscopy
An NAMC condenser, objectives for NAMC, NAMC
slider, slit diaphragms, and centering telescope are
required in order to perform NAMC microscopy.
Attach the condenser and objectives in the same
manner as described for the basic set. For details
on the centering telescope, please see the
description given in Chapter 3, "Microscopy".
To remove a slit diaphragm already inserted, first
sufficiently loosen the centering screws, and lift by
holding the inside of the circumference. Take care
not to press on the slit area.
Remove the tab on one side of the slider and insert
into the condenser slider attachment hole.
Re-attach the tab in its original location.
5 Assembly
E-36
Annular diaphragm Ph2
Slit
diaphragm
Tab
Loosen centering
screws in advance.
Phase slider
NAMC slider