Components Of The System - Nikon Eclipse E600W Instructions Manual

I

Components of the System

If the system has not yet been assembled, see section "III. Assembly" first.
For details on assembling and handling the microscope, see the instruction manual supplied with
the microscope.
This attachment can be mounted on the ECLIPSE E600W, E600 or E400 microscope. Note that
the illustrations in this manual shows the ECLIPSE E600 microscope for convenience. (The
microscopes ECLIPSE E800 and E1000 only allow mounting of the dual-viewing (side-by-side)
attachment. The inverted microscopes TE300 and TE200 only allow mounting of the dual-
viewing (side by side), the triple-viewing and the multi-viewing (for 5 persons) attachment.
Separately available components are required for mounting on these microscopes. For details,
see P.12.)
Depending on the type of set you have purchased, some of the following components may not be
included.
Dual-viewing (face-to-face)
3)
G
Heat protection
shield
1)
Dual-viewing (side-by-side)
2)
3)
G
Mounting ring
1)
Height adjustment
clamp screw
6
6)
5)
2)
4)
6)
5)
7)
4)
This model allows the main observer and the secondary observer to
be positioned face-to-face during observation.
Components
1) Microscope
2) Teaching head F-F
3) Pointer
4) AC adapter
5) Eyepiece tube for secondary observer
6) Eyepieces for secondary observer
This model allows the main observer and the secondary observer to
be positioned side-by-side during observation.
This model can also be mounted on the microscopes ECLIPSE
E800, E1000 and the inverted microscopes TE300 and TE200 with
the separately available components. (Please refer to P.12 for
details.)
When a pointer is going be used, assemble the system so that the
secondary observer will be positioned on the right. If reversed, the
pointer control section will be at the rear of the microscope.
Components
1) Microscope
2) Teaching head S-S
3) Pointer
4) AC adapter
5) Eyepiece tube for secondary observer
6) Eyepieces for secondary observer
7) Support stand