Specifications; Model Numbers Covered In This Specification; Electrical Supply Requirements - Waldorf FNL8127E Installation And Operation Manual

Model Numbers Covered in this Specification

FNL8127E 'Fast-Fri' Electric Fryer, Manual Control
FNL8224E 'Fast-Fri' Electric Fryer, Manual Control

Electrical Supply Requirements

T
HIS APPLIANCE MUST BE EARTHED
QUALIFIED PERSON IN ORDER TO AVOID A HAZARD
Model
FNL8127E
400-415Vac
FNL8224E 400-415Vac
Electrical Connection
Electrical supply connection point is located at the rear of the appliance, approximately 62mm from
the right hand side, 404mm from the rear and 441mm from the floor.
When connecting a this electric appliance to the mains supply, ensure that the following is carried
out:-
 The supply cord shall not be lighter than ordinary tough rubber sheathed (oil
resistant) cord. e.g. H05 RN-F with sufficient current carrying capacity cable sizes.
 The branch supply line shall be overload protected.
 The point of connection shall be as close as practicable to the appliance have an
isolating switch accessible during manual operation of the appliance.
 The supply cord shall be protected against any mechanical or thermal damage.
Refer to the appropriate wiring standards for the size of cable that is to be supplied to an appliance
for the current drawn on that line.
. I
F SUPPLY CORD IS DAMAGED
Power Supply
Voltage Type
3 P+N+E
3 P+N+E
(Single Tank - 27ltr, 17kW).
(Twin Tank - 24 ltr, 14kW).
Warning
,
IT MUST BE REPLACED BY A SUITABLY
.
Total Power
Input
Frequency
50 / 60Hz 17kW
50 / 60Hz 14kW
3

Specifications

Amps
L1 L2 L3
23.6 23.6 23.6
19.5 19.5 19.5