Table of Contents
Advertisement
Selecting a function
To start setting a function, you must first press <Menu>.
The two ways of selecting a function are described below.
The procedures described in this manual are using short-cut operations.
Short-cut operation with the numeric keys
Press <Enter>, then press a three- or four-digit numbers to select the function.
For example, "Press <Menu>, <2>, <1>, <0>, <1>, <Enter>"...
Searching for a function using the cursor key
Even if you don't remember the exact commands needed for an operation, you can search
for and enter the function using the cursor key (q, p, u, t).
To search for a function:
1
Press <Menu>.
2
Search for the function using <q>, <p>, <t> or <u>.
The function table on the next page may be useful for your search.
For example, if you want to set the "Cassette Size," press <
3
Press <Enter> when you have found the function that you want to set.
Going back to the previous screen by pressing <Back>
Press <Back> to go back to the previous menu level.
2-4
G
ettInG started
... you would press
... then
... then
... then
... then
... then
<Menu>
<2>
<1>
<0> (the numeric key zero)
<1>
<Enter>
q>, <u>, <u>.
Advertisement
Table of Contents
