Samsung GX-20 Service Manual page 35

When I open the Device Manager (by clicking Start
(Performance and Maintenance)
[Unknown Devices] or [Other Devices] entries with a yellow question mark (?) beside them
or devices with an exclamation mark (!) beside them.
Case 6
Right-click on the entry with the question (?) or exclamation (!) mark and select
✂
"Remove". Restart the PC and connect the camera the again. For Windows 98
PC, remove the camera driver also, restart the PC, and then reinstall the camera
driver.
In some security programs (Norton Anti Virus, V3, etc.), the computer may not recognise
the camera as a removable disk.
Case 7
Stop the security programs and connect the camera to the computer. Refer to
✂
the security program instructions about how to stop the program.
If a PC connected with the camera stops responding while Windows is starting.
In this case, disconnect the PC and the camera and Windows will start. If the
✂
problem happens continuously, set the Legacy USB Support to disable and
Case 8
restart the PC. The Legacy USB Support is in the BIOS setup menu (The BIOS
setup menu differs from the PC manufacturers and some BIOS menus don't
have Legacy USB Support). If you can't change the menu by yourself, contact
the PC manufacturer or BIOS manufacturer.
The camera is connected to the USB port located on the front of the computer.
When the camera is connected to the USB port located on the front of the
✂
Case 9
computer, the computer may not recognise the camera. Connect the camera to
the USB port located on the back of the computer.
- This Document can not be used without Samsung's authorization -
(Settings)
✁
System (Hardware)
✁ ✁
. INSTALLATION
Control Panel
✁
Device Manager), there are
✁
✁
35