Samsung GX-20 Service Manual page 324

. ADJUSTMENT
* If a lens is attached, the AE sensor can be seen more easily.
✁
T he AE sensor has to be positioned as shown in the following figure without being shifted.
Spot metering frame (Ø2.5)
✂
R emove the adhesive which holds the AE sensor (0-J100).
✄
L oosen the screws and adjust the position of the AE senor (0-J100).
✄
T ighten the screws and check it again.
☎
A fter the adjustment, apply the adhesive to the two areas of the screws for the AE sensor (0-J100).
148
AE sensor (0-J100)
- This Document can not be used without Samsung's authorization -
Center position of the AE sensor
Tolerance : 0.250.85 mm (actual dimension)
Center position of the finder