Setting Up The Power Module - Dell 5000 Series Installation And Operation Manual

Feature
3. Battery status LED
4. 19.5 VDC power adapter port
5. 24V AC/DC power port
6. Sealed lead-acid battery port
7. Bottom release-latch
8. Dell Edge Gateway expansion
port

Setting up the Power Module

WARNING: Before installng the Power Module shutdown the Dell Edge
Gateway and disconnect the power cable.
NOTE: The power module is required to be connected with the Dell Edge
Gateway to enable and use the I/O expansion module.
1 Remove the dust-cap covering the Power Module expansion port on the Dell
Gateway connector.
Indicates the power‑state of the attached
battery.
Connect a +19.5 VDC power adapter to
provide power to your Gateway.
Connect a +24V AC/DC power source to
power your Gateway.
Connect an external battery back to the
power module to provide back-up power
in case of power interruption.
Push both the top and bottom release-
latch to disconnect the power module
from the Dell Edge Gateway.
Connect the power module to the Dell
Edge Gateway for increased power
options and to power the I/O expansion
module.
Power Module Overview 43