Powering On The Dell Edge Gateway; Mounting The Dell Edge Gateway On The Wall - Dell 5000 Series Installation And Operation Manual

• Removing the micro-SIM card

Powering on the Dell Edge Gateway

1 Install the Gateway on the wall mount using the Dell approved
wall mounting
or
Install the Gateway on the rack infrastructure using the Dell approved
DIN-rail mounting
2 Connect the network cable.
or
Install the wireless antenna to enable the wireless connections
3 Connect a display to the Gateway (if required).
4 Connect a keyboard and mouse if accessing the Gateway directly.
5 Connect a SELV/limited energy circuit power source to the Dell Edge Gateway.
6 Connect a grounding cable to the Gateway if required.
7 Press the power button to power on the Gateway.
8 If setting up the system for the first time, complete the operating system setup.
NOTE:
Enterprise, Ubuntu Snappy, or Wind River Linux operating systems.
9 Connect and configure to devices using the RS422/RS485 ports.
NOTE:
corresponding RS422/R485 ports.

Mounting the Dell Edge Gateway on the wall

You can mount the Dell Edge Gateway on a wall by using mounting brackets. The
brackets secure the Dell Edge Gateway to the wall.
1 Secure the two mounting brackets to the rear of the Dell Edge Gateway by
using four screws.
kit.
brackets.
The Dell Edge Gateway is shipped with either Windows 10
Turn on the corresponding dip switches to enable the
Setting up your Dell Edge Gateway 16