Setting Up The I/O Module - Dell 5000 Series Installation And Operation Manual

Feature
1. Cable routing slot
2. RS232 port
3. GPIO port
4. USB 2.0 port
5. USB 2.0 port
6. Top release-latch
7. I/O module expansion
connector and guide pin
8. Power status light
9. Bottom release-latch
10. PCIe x1 card slot
11. I/O module cover removal screw Remove the screw to open the box and

Setting up the I/O Module

CAUTION: Before touching anything inside the system, ground yourself by
touching an unpainted metal surface. While you work, periodically touch an
unpainted metal surface to dissipate static electricity, which could harm
internal components.
NOTE: Install the PCIe expansion card in the I/O Expansion Module before
mounting it on Wall mount or DIN rail.
1 Install the PCIe expansion card in the I/O Expansion Module - optional
2 Remove the dust cap and loosen the access cover screw that secures the I/O
Expansion Module to the cover, slide in the direction shown and carefully lift it
off the module.
Route any cable(s) that has to be
connected to the PCI card installed in the
I/O module.
Connect a RS2325 cable.
Connect a GPIO 8–pin cable.
For USB 2,0 devices
For USB 2,0 devices
Push both the top and bottom release-
latch to disconnect the power module
from the Dell Edge Gateway.
Connect the I/O module to the Dell Edge
Gateway.
Indicates the power state of the I/O
module and the Dell Edge Gateway.
Push both the top and bottom release-
latch to disconnect the power module
from the Dell Edge Gateway.
Install PCIe x1 card on the I/O module.
install the PCIe card.
I/O Module Overview 32