Multitech 410 Configuration Manual page 44

FXS Loop Start Parameters. The parameters applicable to FXS Loop Start are shown in the figure below
and described in the table that follows.
Field Name
FXS (Loop
Start)
Dialing Options fields
Inter Digit
Timer
Message
Waiting
Indication
Inter Digit
Regeneration
Time
Ring Count,
FXS
FXS Options,
Current Loss
44
FXS Loop Start Interface: Parameter Definitions
Values Description
Y/N Enables FXS Loop Start interface type.
1 - 10 seconds This is the length of time that the MultiVOIP will wait between
digits. When the time expires, the MultiVOIP will place the call.
Default = 2.
-- If "Register with Communication is enabled", this field enables
message waiting indication on FXS channels. Choices are "Light" or
"Stutter Dial Tone".
in milliseconds
The length of time between the outputting of DTMF digits.
Default = 100 ms.
Maximum number of rings that the MultiVOIP will issue before
1-99
giving up the attempted call.
When enabled, the MultiVOIP will interrupt loop current in the FXS
Y/N
circuit to initiate a disconnection. This tells the device connected to
the FXS port to hang up. The Multi-VOIP cannot drop the call; the
FXS device must go on hook.
Chapter 3 – Related MultiVOIP Setup Parameters
Multi-Tech Systems, Inc. Avaya Communication Manager Guide