Power Switch - HP 200 G1 ST Maintenance And Service Manual

Power switch

The power switch is attached to the left, front of the chassis. The power switch is removed by pulling it away
from the front of the chassis.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4. Disconnect the cable from the system board connector labeled F_PANEL, and remove the cable from the
clips built into the basepan.
5. From the inside of the chassis, press down on the tab at the top of the power switch assembly (1), and
the pull the assembly away from the front of the chassis while routing the cable through the hole in the
chassis (2).
To install the power switch, reverse the removal procedures.
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 26).
15).
14).
Power switch 33