Threading The Needle With The Needle Threader - ELNA 664 Instruction Manual

w
r
q
e
t
Threading the Needle with the Needle
Threader
IMPORTANT:
When threading the needle, be sure to:
– turn the power switch off.
– lower the presser foot.
Hold the needle threader with the triangle mark
facing up. Insert the thread into the Y-notch of the
threader from the right.
q Triangle mark
w Y-notch
Slide the threader down along the needle while
pushing it gently until the threader pin goes into
the needle eye.
Place the V-notch over the needle just above the
needle eye.
e V-notch
Push the threader until the threader pin comes out
through the needle eye with a loop of thread.
r Threader pin
Remove the threader from the needle slowly, leaving
the thread loop behind the needle eye.
Using the hook, pull the loop of the thread out
to the back.
t Hook
52