Threading The Needle With The Needle Threader - ELNA eXpressive 970 Instruction Manual

⁄3
@0
q
⁄4
z
q
w
x
e
c
v
r
!9
20
⁄3 Pass the thread through the hole in the presser foot.
Draw the thread up and pinch the thread tail with the
holder spring.
!9 Hole in the presser foot
@0 Holder spring
⁄4 Pull up the tension release lever to close the tension
disks.
q Tension release lever

Threading the needle with the needle threader

z Hold the needle threader with a triangle mark facing
up. Insert the thread into the Y-notch of the threader
from the right.
q Triangle mark
w Y-notch
x Slide the threader down along the needle while
pushing it gently until the threader pin goes into the
needle eye.
Place the V-notch over the needle just above the
needle eye.
e V-notch
c Push the threader until the threader pin comes out
through the needle eye with a loop of thread.
v Remove the threader from the needle slowly, leaving
the thread loop behind the needle eye.
Using the tweezers, pull the loop of the thread out to
the back.
r Tweezers