Daisy Chaining - ATEN Master View CS-1708 User Manual

Daisy Chaining

To control even more computers, up to 31 additional switches can be daisy chained
down from the first unit. As many as 512 computers can be controlled from a single
console in a complete installation. Tables showing the relation between the
number of computers and the number of Master View CS-1708 / CS-1716 units
needed to control them are provided on p. 45 in the Appendix.
To set up a daisy chained installation, do the following:
1. Make sure that power to all the devices you will be connecting up has been
turned off.
2. Use a daisy chain cable set (described in the Cables section, p. 4), to
connect the Chain Out port of the parent switch to the Chain In port of the
child switch (First Station Out to Second Station In, Second Station Out to
Third Station In, etc.).
Note: You cannot use the Chain In port of the First Station Master View,
since it is the highest level parent.
3. Use KVM cable sets (described in the Cables section, p. 4), to connect any
available CPU Port on the CS-1708 / CS-1716 installation to the Keyboard,
Video and Mouse ports of the computers you are installing.
4. Repeat the above steps for any additional CS-1708 / CS-1716 units you
wish to add to the chain.
5. Power up the installation according to the following procedure:
a) Plug in the power adapter for the First Station.
Wait for the unit to ascertain its Station ID and display it on the Station ID
LED. (The Station ID for the First Stage unit is 01, the ID for the Second
Stage unit is 02, the ID for the Third Stage unit is 03, etc.).
b) Plug in the power adapters for each Station on the installation in turn
(Second Station, then Third Station, etc.).
In each case, wait for the Station ID to be ascertained and displayed on the
current Station before plugging in the next one.
c) After all the Stations are up, power on the computers.
2004-04-27
Installation
11.