ATEN Master View CS-1708 User Manual page 37

(F4 ADM: continued)
Setting
SET QUICK This function lets the Administrator select which Ports to include as
VIEW PORTS Quick View ports.
Note: Only the Ports currently chosen for the LIST view on the main
OSD screen (see p. 26), show up here.
w To select/deselect a port as a Quick View Port, use the
Navigation Keys to move the highlight bar to it, then
Press [Space].
w When a port has been selected as a Quick View Port, an
arrowhead displays in the QV column of the LIST on the Main
Screen to indicate so. When a port is deselected, the
arrowhead disappears.
w If one of the Quick View options is chosen for the LIST view
(see p. 26), only Ports that have been selected here will show
up on the LIST display on the main OSD screen.
w If one of the Quick View options is chosen for Auto Scanning
(see p. 28), only Ports that have been selected here will be Auto
Scanned.
The default is for no ports to be selected.
SET This function allows the Administrator to define User access to the
ACCESSIBLE computers on the installation on a Port-by-Port basis. For each
PORTS User, select the target Port; then press the [Spacebar] to cycle
through the choices: F (Full access), V (View Only) or blank. Repeat
until all access rights have been set, then press [Esc]. The default
is F for all users on all Ports.
Note: A blank setting means that no access rights are granted. The
Port will not show up on the User's LIST on the Main Screen.
(Table continues on next page)
Function
2004-04-27
OSD Operation
31.