Table of Contents
Advertisement
CS-1708 / CS-1716 User Manual
(F4 ADM: continued)
Setting
RESET
If you change the position of one of the Stations in the daisy chain,
STATION IDS
the OSD settings will no longer correspond to the new situation.
This function directs the OSD to rescan the Station positions of the
entire installation and updates the OSD so that the OSD Station
information corresponds to the new physical layout.
Note: Only the Station Numbers get updated. Except for the Port
Names, all Administrator settings (such as Set Accessible Ports, Set
Quick View Ports, etc.), for all of the computers affected by the
change, have to be manually redone.
SET
Specifies the operating platform of the computer attached to each
OPERATING
port. For each port, press the [Spacebar] to cycle through the
SYSTEM
choices (PC, Sun, Mac, and SPC*). Repeat until all the ports have
been set, then press [Esc]. The default is PC.
FIRMWARE
In order to upgrade the CS-1708 / CS-1716's firmware (see p. 37),
UPGRADE
you must first invoke Firmware Upgrade Mode with this setting.
KEYBOARD
Sets the keyboard language layout for the computer attached to
LANGUAGE
each port. Choices are: Auto, English, French, German, and
Japanese. Auto (the default), sets the keyboard language according
to the keyboard language of the computer.
* 1. PC stands for PC compatible. This is the choice that should be made for
all operating systems other than Sun and Mac.
2. If you are installing a Sun or Mac computer, before you run it for the first
time you must set the correct operating system for the port it is connected
to with this function, otherwise, it will not boot.
3. SPC stands for Special Case. For certain operating systems (such as
FSBD), you may need to choose this option if you run into startup
problems. If this occurs, please contact technical support for further
information
32.
Function
2004-04-27
Advertisement
Table of Contents
