Table of Contents
Advertisement
CS-1708 / CS-1716 User Manual
Troubleshooting
Symptom
Possible Cause
After
Operating System
installation,
not properly set for
my Sun/Mac
its port.
computer
does not boot.
Keyboard
Keyboard and/or
and/or
mouse need to be
Mouse not
reset.
responding.
No connection to the
computer.
KVM switch needs
to be reset.
Device not
Windows timing
recognized
problem.
message
(Windows)
Limited Warranty
IN NO EVENT SHALL THE DIRECT VENDOR'S LIABILITY EXCEED THE PRICE
PAID FOR THE PRODUCT FROM THE DIRECT, INDIRECT, SPECIAL, INCIDEN-
TAL OR CONSEQUENTIAL DAMAGES RESULTING FROM THE USE OF THE
PRODUCT, DISK OR ITS DOCUMENTATION.
The direct vendor makes no warranty or representation, expressed, implied, or statutory
with respect to the contents or use of this documentation, and specially disclaims its quality,
performance, merchantability, or fitness for any particular purpose.
The direct vendor also reserves the right to revise or update the device or documentation
without obligation to notify any individual or entity of such revisions, or update. For further
inquires please contact your direct vendor.
50.
Action
When you install a Sun or Mac computer,
before you run it for the first time you must set
the correct operating system for the port it is
connected to, otherwise, it will not boot. See
SET OPERATING SYSTEM, p. 32, for details.
Unplug the cable(s) from the console port(s),
then plug it/them back in.
Check the cable from the switch to the
computer to make sure it is properly connected.
Power off all devices on the installation (see the
note at the top of p. 9); power off the KVM
switch; wait five seconds; then power up.
1. Unplug the KVM cable from the computer's
USB port.
2. Go into Windows' System Settings and
remove the Unknown Device entry.
3. Plug the KVM cable back in. Windows will
now recognize the device.
2004-04-27
Advertisement
Table of Contents
