Configuring The E-Mail Environment - Fuji Xerox DocuCentre-II 3005 Administrator's Manual

13 Using the iFax Service
3) Select one from [DHCP], [BOOTP], [RARP], [DHCP/Autonet] and [Manual], and
Note
4) Select [TCP/IP - IP Address] and select [Change Settings].
5) Enter the IP address using the numeric keypad.
Note
6) Select [Save].
7) Configure [TCP/IP – Subnet Mask] and [TCP/IP – Gateway Address] as above.
Note
13
4
Select [Close] repeatedly until the [System Settings] screen is displayed.
5
Select [Exit].
6
After the machine is restarted, print out a settings list to confirm that the ports are
enabled and TCP/IP is configured.
For information on how to print a settings list, refer to "Print Report/List" under "Chapter 13 Machine
Status" in the User Guide.

Configuring the E-mail Environment

The following describes the configuration procedure for the e-mail environment.
Note
For information on how to use CentreWare Internet Services, refer to "Using CentreWare Internet
Services" (P.63).
1
Display the [System Administrator Menu] screen.
1) Press the <Log In/Out> button.
2) Enter the user ID with the numeric keypad or a keyboard displayed by pressing
Note
3) Select [System Settings].
2
Set an e-mail address, host name, and domain name.
1) Select [System Settings].
2) Select [Network Settings].
3) Select [Machine's E-mail Address/Host Name].
4) Select [E-mail Address] and then select [Change Settings].
5) Enter an e-mail address using the keyboard displayed.
6) Select [Save].
7) Set a host name and a domain name as above.
128
then select [Save]. If you select anything other than [Manual], proceed to Step 4.
• When using a DHCP server, also configure the WINS (Windows Internet Name Service)
server. To set a DHCP server, use CentreWare Internet Services. For details, refer to "Using
CentreWare Internet Services" (P.63).
• Enter the IP address in the format "xxx.xxx.xxx.xxx". The "xxx" must be a numeric value in
the range from 0 to 255. However, 224-255.xxx.xxx.xxx, and 127.xxx.xxx.xxx cannot be
used.
• When you make an entry mistake, press the <C> (Clear) button and enter again.
• When moving to the next value without entering all 3 digits, select [Next].
• Enter the gateway address in the format "xxx.xxx.xxx.xxx". The "xxx" must be a numeric
value in the range from 0 to 255. However, 224-255.xxx.xxx.xxx, and 127.xxx.xxx.xxx
cannot be used.
• Specify the subnet mask by a combination of the numbers 0, 128, 192, 224, 248, 252, and
255. However, you cannot use 0 between non-zero values.
• If you do not set the gateway address, enter "0.0.0.0".
• The configuration can also be performed using CentreWare Internet Services.
[Keyboard], and select [Confirm].
• The default user ID is "11111". When using the Authentication feature, a passcode is
required. The default passcode is "x-admin".