Preparations; Installation Procedure; Installation Overview - Fuji Xerox DocuCentre-II 3005 Administrator's Manual

6 Installation When Using NetWare

Preparations

Prepare the following items to install the machine when using a NetWare network.
NetWare server
TCP/IP or IPX/SPX network environment
CD-ROM of the Driver CD Kit (provided with the machine)
NetWare Kit (optional) or Adobe PostScript 3 Kit (optional)

Installation Procedure

Installation Overview

The machine supports a PServer mode both for the NetWare Directory Service and
Bindery Service. The PServer mode enables the machine to function as a print server
and to capture print jobs in the print queue to output. The printer created for the
machine consumes one file server license.
Note
Supported interfaces
100BASE-TX
6
10BASE-T
Supported frame types
Ethernet II specification
IEEE802.3 specification
IEEE802.3 / IEEE802.2 specification
IEEE802.3 / IEEE802.2 / SNAP specification
Note
The following describes the configuration procedure to connect the machine to a
NetWare network.
Configuration on the Machine
- To use IPX/SPX, configure the machine using the CD-ROM of the Driver CD Kit
- To use a LPD port in NDPS, configure the machine using the CD-ROM of the
46
• The machine does not support a Remote Printer (RPrinter) mode.
• You can use the machine as a printer in a NDPS environment by using a Novell NDPS
Gateway. When using in a NDPS environment, settings of the machine to be used under a
NetWare print environment are required. Or, you need to enable LPD in advance and set it
as a gateway destination in a Novell NDPS Gateway setup. However, attribute information
that can be set or captured by NDPS is not supported.
• The machine will send packets of each frame type on the network, and will initialize for the
same frame type as the first reply packet received. You can fix a frame type in use.
However, if there are multiple protocols running on the same network, use Ethernet II
specification.
• Some network equipment (hubs, etc.) may not support the automatic frame type detection. If
a data link indicator corresponding to the port of the network equipment connected with the
machine does not light up, change the settings of the frame type of the machine to the frame
type of the file server. Configuration can also be performed using CentreWare Internet
Services.
after enabling the NetWare port of the machine.
Driver CD Kit after enabling the LPD port of the machine and setting TCP/IP.