Four-Bay Lff Hot-Plug Drive Backplane - HP ProLiant DL120 Gen9 Maintenance And Service Manual

Remove the non-hot-plug drive backplane.
8.
To replace the component, reverse the removal procedure.

Four-bay LFF hot-plug drive backplane

To remove the component:
If installed, remove the security bezel
1.
Power down the server (on page 29).
2.
Remove all power:
3.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Extend ("Extend the server from the
4.
page 30) the server from the rack.
Remove the access panel
5.
Remove all hot-plug hard drives
6.
Disconnect all cables connected to the drive backplane.
7.
("Remove the security bezel
rack" on page 30) or remove
("Access panel" on page 36).
("Hot-plug drive" on page 35).
(optional)" on page 29).
("Remove the server from the
Removal and replacement procedures 38
rack" on